5. ADJUSTMENT
BAS-7610
5-10
<Thread take - up spring>
1. Stroke : Adjust → Loosen set-screw (2), Turn the whole unit of the tension regulator assembly
2. Force : Adjust → Insert a screwdriver tip into the groove of tension stud (3), Turn the tension stud
(The tension in the thread take-up spring when it is pulling the upper thread straight to the side at the point where the
spring starts to move.)
<Thread guide, R>
In the case of “ X2.4 rotary hook “ specification, the thread guide, R can also adjust thread tightening. (It is because the
width of adjustment of a position is large.)
It will be good tightening if a size A is enlarged.
If a size A is enlarged when using inelastic thread, thread may break.
Reference
T - 105 (twisted) thread : Size A → 12 - 19 mm
Inelastic thread : Size A → 10 mm or less
1338S
(1)
(1)
5 - 10 mm
1339S
(2)
X1.7 rotary hook
X2.4 rotary hook
(3)
(3)
.4 -
.
N
0.4 - 0.6 N
1340S
1341S
1679S
Comments to this Manuals