Brother Z-8550A Instruction Manual download pdf (Page 17)

Z-8550A, 8560A

4. INSTALLATION

10. Cotton stand

(1) Cotton stand

NOTE:

Securely tighten the nut (4) so that

the two rubber cushions (2) and the

washer (3) are securely clamped and

so that the cotton stand (1) does not

move.

11. Knee lifter plate

(1) Knee lifter plate

(2) Bolt

* Loosen the bolt (3) and move the

knee lifter plate (1) to a position

where it is easy to use.

1. Turn the machine pulley so that the feed dog is below the

top of the needle plate.

2. Lower the presser foot (5) by using the lifting lever (4).



3. Loosen the nut (6).

4. Turn the screw (8) to adjust so that the amount of play in

the knee lifter (7) is approximately 2 mm when the knee

lifter plate (1) is gently pressed.

5. Securely tighten the nut (6).

6. Loosen the nut (9).

7. Turn the screw (10) until the distance between the end of

the screw (10) and the knee lifter (11) is approximately 4

mm.

8. Turn the adjusting screw (10) to adjust so that the

presser foot (5) is at the desired position within a

distance of 10 mm of the needle plate when the knee liter

plate (1) is fully pressed.

9. After adjustment is completed, securely tighten the nut

(9).

2098M

3362M

2101M

3789M

Within 10 mm

3790M

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 95 96

No comments

Brother Z-8550A Instruction Manual Page 17