Brother Z-8550A Instruction Manual download pdf (Page 50)

Z-8550A, 8560A

7. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

7-2. Adjusting the needle up stop position

1. While pressing the needle up/down key (1), turn on the

power switch.

2. “n.0 xx” will appear in the main display (2).

(“xx” is the setting value for the needle up stop position,

and “0” is the default setting.)

3. Press the

or key (3) to change the setting value

for the needle up stop position.

• If you press the key, the setting value will increase

up to 10 and the needle up stop position will become

lower.

• If you press the key, the setting value will decrease

down to -10 and the needle up stop position will become

higher.

4. Press the ENTER key (4) for two seconds or more.

A long buzzer will sound and the main display (2) will

change to stitch number display mode. (This completes

the needle up stop position setting.)

* A setting value of “10” corresponds to an angle of rotation

of approximately 10° for the upper shaft.

NOTE:



If the needle bar is not at the needle up stop position,

“UP” will be displayed.

2138M 2139M

3454M

3455M

Becomes

higher

Becomes

lower

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

No comments

Brother Z-8550A Instruction Manual Page 50