Brother Z-8550A Instruction Manual download pdf (Page 81)

Z-8550A, 8560A

13. OPTIONAL PARTS

1. Pass presser bar U (15) through the bushing (16) from

above.

2. Use a spanner or similar tool to securely tighten presser

bar tip A (17) or presser bar tip B (18) into presser bar U

(15).

3. Fit the guide bracket (13) into presser bar U (15) and the

groove (A) in the arm, and provisionally secure it in place

with the screw (12).

4. Install the presser foot to presser bar tip A (17) or presser

bar tip B (18).

5. Install the spring guide collar (11), spring guide (9) and

spring (10).

6. Tighten the adjustment screw (8).

7. Loosen the screw (12) , align the presser foot with the

groove in the needle plate (20), and then carry out the

adjustment in “Adjusting the presser foot height”. (Refer

to P. 62.)

* When tightening the screw (12), lower the guide

bracket (13) until it is touching the lifter lever (19), and

then tighten the screw (12).

8. Install the face plate (6) with the screws (4) and the

screw (5).

9. Install the thread take-up guard (3) with the screws (2).

Aligned

3550M

3815M

3816M

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 95 96

No comments

Brother Z-8550A Instruction Manual Page 81