7. FOLDING MACHINE
BAS-7610
7-41
2. The flap margins at the bottom on both sides are not tucked in.
<Cause>
A. The flap margin on both sides are too small.
Adjust the flap margin to 12-15 mm.
B. Tucking blade RD or LD is improperly positioned.
Shift the tucking blade backward, then adjust it so that its edge is aligned with the center blade corner when the
cylinder driving the tucking blade works. (The alignment does not have to be perfect.) At this time, check that the
tucking blades come into the clearance between the D and the RDD or LDD tucking blades.
C. The height between tucking blade RD or LD and tucking blades D and RDD or LDD is improperly
adjusted.
If tucking blade RD or LD is attached above tucking blade D or below tucking blade RDD or LDD, reattach
tucking blade RD or LD, as shown in the figure on the left.
Tucking blade RD
Center blade
1845S
Tucking blade D
Tucking blade RDD or LDD
1 mm
Tucking blade RD
1847S
Connecting block SR assembly
Connecting block SL assembly
Bolt 4X8
Setting plate
Bolt 5X25
Tucking blade LDD square J
Tucking blade
R square J
Tucking blade
L square J
Chamfering blade RJ
Chamfering blade LJ
1846S
Foldin
clam
assembl
Tucking blade RD
Tucking blade RD
Tucking blade D square J
Tucking blade RDD square J
Comments to this Manuals