Brother MFC7150C User Manual download pdf (Page 38)

MFC SETUP AND CONNECTIONS

Connections

The external TAD must be plugged into the back side of the MFC, into the

jack labeled EXT. Your MFC cannot work properly if you plug the TAD into

a wall jack.

Plug the telephone line cord from the wall jack into the back side of the

MFC, in the jack labeled LINE.

Plug the telephone line cord from your external TAD into the back side

of the MFC, in the jack labeled EXT. (Make sure this cord is connected

to the TAD at the TAD’s telephone line jack, and not its telephone set

jack.)

Set your external TAD to four rings or less. (The MFC’s Ring Delay

setting does not apply).

Set the external TAD to answer calls.

Record the outgoing message on your external TAD (see below).

(For MFC 7160C Only) Set the MFC’s Message Storage to

VOICE:EXT.

Press

Mode

on the MFC until the FAX and FAX/TEL lights are on.

Outgoing Message (OGM)

Timing is important in recording this message.

Record 5 seconds of silence at the beginning of your message. (This

allows your MFC time to listen for the fax CNG tones of automatic

transmissions before they stop.)

Limit your speaking to 20 seconds.

End your 20-second message by giving your Fax Receive Code for

people sending manual faxes. For example:

“After the beep, leave a message or send a fax by pressing 51 and

press Start.”

Connecting an External Telephone

Your MFC is equipped with a handset that you can use as a regular phone.

However, you can also connect a separate telephone (or telephone

answering device) directly to your MFC.

Connect the modular plug on the telephone’s line cord to the jack labeled

EXT. on the back side of the MFC.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 274 275

No comments

Brother MFC7150C User Manual Page 38